Build mediacenter install#
Build mediacenter Pc#

Be careful not to over tighten the screws or the acrylic will crack! Just tighten enough to be snug. Using a magnetic-tipped screwdriver, you can slide each nut into the T-slot built into the top and bottom pieces of the enclosure, then thread the screw through the side and into the nut. Once all tabs are fitted into place, secure the sides using 8 M3 screws and hex nuts. Place the last side piece on top to form the complete box. Lay the four-sided assembly over onto one of the side pieces as shown, being careful to keep all the tabs in their respective slots. This part is a little tricky, so you may need a friend to provide a third hand. Place the top panel in place, so that the tabs are secured through the notches in the front and back plates of the enclosure. The FLIRC should extend through the hole in the front side a small amount, so that it has a good view to pick up signals from your remote control. 4x M2.5x12mm screws (M2 screws will also work)ДЇlip the front and back panels up into place.

C&K 8125 with J81 snap-in frame)ДҐ.a pidrive power cable panel mount adapter (3D printed) orДҐ.b Sabrant power cable panel mount adapter (3D printed)Д¤. 1x Ethernet to panel mount ethernet cable with mounting screwsДЎ. 1x USB type A to female USB cable (extender)Д¤. 1x USB type A to panel mount USB cable with mounting screwsДЈ. 1x HDMI to panel mount HDMI cable with mounting screwsДў. A remote control that you have programmed to work with your FLIRC.ДЎ. OpenELEC is an embedded operating system built specifically to run Kodi (formerly known as XBMC), the open source entertainment media hub.ДЄlso, be sure to program your FLIRC using the pairing GUI they provide for the remote control that you plan to use, because you can't easily remove the device from the piCentr enclosure once it's assembled.Дў.a Western Digital pidrive kit (HDD and cable adapter) orДў.b Sabrant USB 2.0 to SATA/IDE Hard Drive converter with power supply and the 2.5вЂќ HDD of your choice.Д¤.

Build mediacenter install#

I recommend you install OpenELEC on your raspberry pi micro SD card before you start (you can still insert and remove the micro SD card through a slot in the bottom of the piCentr later if you want to make any changes). You can run any OS that you would like on your piCentr. Note to the laser cutters - the four sides of the enclosure should be cut from 3mm material, but the top and bottom are cut from 6mm material.

You'll need to get those and get the parts cut / 3D printed first unless you are buying them in a kit. The design files for the laser cut and 3d printed parts of the piCentr design are available on GitHub. The design also sports a power-wake button and a cooling fan.

Remote control of the appliance is supported by installing a FLIRC USB device and the remote of your choice. A 3D printed internal chassis is part of the design, which holds the Pi 2 and up to two 2.5вЂќ HDDs, and is specially suited to use with the Western Digital pidrive. The layout of the enclosure is meant to keep all cabling tidy and inside out of view, with accessible ports for everything you need, including front a front USB port, and rear HDMI and ethernet ports.

Build mediacenter Pc#

PiCentr is an Open Source enclosure designed specifically for people who wish to build a media center PC using the Raspberry Pi2.